Curing press VL 63,5 (65)

Technical parameters:		Operation media:
Inner diameter of steam dome	1.335 (1.580) mm	Steam for crowning	up to 0,4 MPa
Maximum height of semiproduct	1000 mm	Steam for dome	to 0,8 MPa
Max lockup force / 1 mould	5.000 KN	Steam for membrane	to 2,0 MPa
Minimum mould height	255 mm	Hot power water	to 3,2 MPa
Maximum mould height	635 (650) mm	Hydraulic oil	-
Base diameter: minimum	15"	Hydraulic water	to 2,1 MPa
Base diameter: maximum	25"	Cooling water	to 2,1 MPa
Weight (approximate)	54.200 (59.200) kg	Vacuum	to 53 kPa

Loading device:		Voltage for press and accessories:
Total height	As per the customer's requirements	Operating voltage	380/220 V AC
Loading capacity	2 x 180 (200) kgs	Protective PE lines	PE
Blades (chuck)	Short / long	Neutral line	PEN
		Voltage for PLC	220 V AC
		Control voltage PLC	24 V DC
		Other control voltage	24 V DC
		Valve control voltage	24 V DC
		Drive brake voltage	220 V AC
		Signal voltage	24 V DC
		Compressed air	0,7 MPa

Description of curing press VL 63,5" and 65"

The VL 63.5" curing press is a double-dome press with the B.O.M. membrane system for moulding and curing of diagonal and radial tyres for trucks.
The VL 65" curing press is a modified version of VL 63.5“complying with the requirements of customers concerning the sizes of the moulds used and, at the same time, including all the modernising steps formerly applied to VL 63.5“.

Lifting and tilting of the upper parts of steam domes is solved by means of pulls and eccentric wheels. Those are driven by means of an electric motor via a gearbox and a set of tooth wheels located on both sides of the press stand. As standard, we use double-dome mechanic presses of the Lenze brand.

Other drives are hydraulic. The press is equipped with a thermal insulation of the steam domes.

The activity is controlled from a control cabinet, including controlling of the added equipment (loading and stabilising device). As standard, we provide our presses with Siemens or Alain Bradley control system.

In automatic mode, the press operates from gripping the semiproduct in front of the press, up to lowering of final tyres to the collecting belt.

Presses are typically delivered in a version with steam domes or with heater plates. In both cases, the pressure vessel certificate is a matter of course.

The moulding and curing process is fully controlled and monitored by means of PLC Siemens S 7 (or as per the customer's request)

The loading device allows relocation of semiproduct to the press and subsequent relocation of final tyres off the press.

All the above data can be modified as per the customer's request.